Sliding gate operator main control board – Key Automation

Sliding gate operator main control board – Key Automation

The sliding gate operator main control board for a sliding gate opener, up-and-over door, or electromechanical barrier, 24 Vdc, built-in radio receiver

The CT10324 control unit is the most modern and efficient control device for 24VDC Key Automation gear motors for sliding gates; any other use is to be considered improper and is therefore prohibited.
The 5-digit/14-segment display of the CT10324 control unit makes it easier to read the acronyms, facilitating programming and monitoring of the automation; the menu structure allows easy setting of work times and operating modes.

More information about the sliding gates:

Sliding gate automation is usually included on the gate.

The single sliding gate is wider than the width of your driveway. It slides to one side of the drive opening on wheels that run along a track.

A single electric gate opener is mounted to one side of the drive entrance. The sliding gate motor is positioned so that a cog on the motor’s output shaft meshes with a toothed rack mounted along the inside of the gate. Therefore, as the electric sliding gate motor turns, the cog rotates in the rack and draws the gate along.

A sliding gate opens along a length of straight gate track more than twice the width of the driveway. This starts at the pillar or gate post on one side of the opening and crosses the drive past the opposite pillar. The sliding gate track is long enough for the gate to slide along to completely clear the drive entrance.