4 Ways to Troubleshoot Your Automated Gate Remote Entry Problems

4 Ways to Troubleshoot Your Automated Gate Remote Entry Problems

Automated gates are great as they allow you to open/close the gate remotely from your car. Unfortunately, sometimes due to weather, environmental elements, or some other reasons, these gates may stop functioning properly. The good news is, there are ways to troubleshoot the gate to find the cause of the problem and fix it so that you can have your automated gate working again.

Following are 4 ways to troubleshoot your automated gate remote entry problems:

1. Try Using Another Control

The first thing you should do when your automated gate is not opening/closing remotely is to try another control such as intercom or keypad and see if it works properly. If another control works correctly, then you should try another remote control. If that also works, then it means that the batteries of your remote control are flat. If none of the remote controls work but the gate opens/close correctly via other controls, then there is a problem with your remote control receiver.

2. Check the Power Supply

Check whether the power supply to your automated gate is on. If you are not sure where the electrical isolation is, then check the fuse box and see if there are any switches that are in the off position. You should also read the labels of the switches that are off and if any of them are for the automated gate, then switch it back on. If the switch stays on then you should try the gate again. If it is on and you still cannot operate the gate, then there may be another issue such as a damaged cable to the motor, a faulty motor, or an electrical joint on the cable with water in it. On the other hand, if the trip switch returns to off position when you switch it on, then you will need professional help.

3. Check the Internal Fuses of Control Panel

Your automated gate stops working if the internal fuses of the control panel are blown. So it is recommended that you check them. It is highly recommended that you isolate the gate electrics before you check the fuses. Don’t proceed if you don’t know how to switch the power off. After switching the power off, open up the control panel enclosure and carefully inspect the main circuit board for the labeled fuses. Open them one by one and take a look at the glass fuse inside. You will see a fine silver wire inside the fuse if it is not blown. On the other hand, if the fuse has blown then you should look for replacements.

4. Call an Automated Gate Repair Company

If none of the above-mentioned ways help, then it is recommended that you call an automated gate repair company. Not only will those professionals provide the parts and repair you need, but they will also help tune up your automated gate system so that it lasts a long time without any issues.

For top-notch automatic gates for your home or business, Royal Electronic is the trusted local choice. To get ideas and to see some recent examples of our work, take a look at our YouTube Channel. When you are looking for a new gate or any related equipment, we welcome you to either contact us through our website or call us at (778) 384-2800 and one of our friendly representatives will be glad to answer any questions you have or arrange a free consultation with no obligation.

4 thoughts on “4 Ways to Troubleshoot Your Automated Gate Remote Entry Problems”

    1. Hello Ms. Laila

      We hope the information on our site was useful to you.
      We will try to provide useful information, more complete than the past, for you and other visitors.

      Best regards,
      Royal Electronic

  1. looking for a schematic for a FAAC 425D 24 volt gate controller. it closes but does not open. is this available, or is there an inexpensive replacement controller available?

    1. Hello Harry,
      Thank you for your message.
      If you looking for an instruction of FAAC 425D click here.
      If you looking for a remote control for your gate operator, do not worry about that. Please send your address to our email (info@retcc.ca).

      Best regards,
      Royal Electronic

Leave a Reply

Your email address will not be published. Required fields are marked *